FOCUS ON MORE THAN 20 YEARS
Longyou provides you with the most professional planer milling machines, surface grinders and other perfect solutions
Hot Keywords: Gantry Milling Machine, Horizontal Milling Machine, Double Milling Machine
DONGGUAN LONGYOU HARDWARE MACHINERY CO. LTD.
Add：Humen Road East of Town Management District Dongguan City Guangdong Province
ABOUT US PRODUCTS NEWS CONTACT US
COPYRIGHT © 2018 DONGGUAN LONGYOU HARDWARE MACHINERY CO. LTD. ALL RIGHTS RESERVED 粤ICP备08128900号 POWERED BY WWW.300.CN
Problems in the operation of double-head milling machine
Two-head milling machine should pay attention to the problem of the process:
1. The operator must stick to his position and be meticulous in his operation and not be irrelevant to the work. Stop the machine when you leave the machine and turn off the power and air supply.
2, according to the rules of processing. It is not allowed to arbitrarily increase the feeding amount, grinding amount, and cut (grinding) cutting speed. Super-standard, overloaded, and overweight machine tools are not allowed. It is not allowed to use rough machines and small machines.
3, the tool, the workpiece should be clamped correctly and fastened firmly. Do not touch the machine when loading or unloading. Find the tool and the workpiece is not allowed to hit the hammer. Do not tighten the tool or workpiece by increasing the torque with a longer handle.
4. Do not install thimble, cutters, knife sleeves, etc. that are inconsistent with the taper or the hole diameter, the surface is nicked or not clean in the double-end milling machine spindle taper hole, tailstock sleeve taper hole and other tool mounting holes.
5, double-head milling machine transmission and feed mechanism of mechanical transmission, tool and workpiece clamping, adjustment and manual measurement of the workpiece process should be in the cutting, grinding termination, cutting tools, abrasives after the workpiece is parked get on.
6, should maintain the sharpness of the tool, abrasive, such as blunt or cracking should be timely wear or change.
7. In the cutting and grinding of double head milling machine, the tool and grinding tool do not leave the workpiece and no parking is allowed.
8. It is not allowed to disassemble the safety protection device on the machine without authorization. The machine tool lacking the safety protection device is not allowed to work.
9. In addition to throttling, the hydraulic system is not allowed to be adjusted privately.
10. In the machine tool, especially the guide rail surface and the work surface, it is not allowed to directly place tools, workpieces and other debris.